You’ll spend between $500 and $3,000 or $1 to $3.50 per square foot to paint concrete. However, expect to pay $2 to $7 per square foot since concrete almost always needs a coat of primer first. Double that price if the concrete requires stripping. Concrete is porous. Sealing it not only helps blend foundations and walls with your home’s aesthetic, but also seals it against water. Repairing or resurfacing concrete costs $300 to $500 for every 100 square feet. House Painting Westminster
If less than half the old paint is left, however, it may be worth stripping it all off. Guertin gets rid of stubborn remnants using shrouded grinders (like the PaintShaver), infrared paint strippers (such as the Speedheater), or chemical strippers (like Multi-Strip), then smooths the wood with a course or two of sanding. When siding (or bank accounts) can't take the shock of a total strip job, Rich O'Neil, of Masterwork Painting in Bedford, Massachusetts, has successfully hidden rough, well-adhered paint under Peel Bond, a thick primer.
O'Neil patches shallow holes and divots with Ready Patch because it dries fast, sands smooth, and stays flexible. Deep cracks and rotten spots are best repaired with two-step epoxies, such as those made by Advanced Repair Technology. (For a step-by-step instructions, see Repairing Rot with Epoxy.) The days of using polyester auto-body fillers on wood are over. "They cure too hard," says Portland, Oregon–based painting contractor Kathleen George. "They look good at first, but then they peel away." House Painting Westminster
The next step is to save all the colors you want to try. Once you have all the hues you like, go to the next procedure which is to paint the room. There is a reset button so you can remove all the changes you have made. Get the summary of the colors you used using the Review tab. Finally, save the project in JPG format which is only possible if you have an account. You can also share it on social media sites. Westminster Home Painting
Small random-orbit or pad sanders make this job go faster. (Wallis first covers these boundaries with Synkoloid patching compound so no edge is visible after sanding.) As shown, you want to make sure that there is a feathered, smooth transition from exposed wood to old paint. For areas that might get close scrutiny, you can follow up with a 100- or 120-grit rubdown to erase any scratches. House Painting Westminster